How to Start a Fire with Household Items

– [Voiceover] Sometimes getting your wood to catch fire can be a real pain. And with the cold season on it’s way, you may need to resort to buying an expensive starter log to get your fire going to keep warm. Today, we’re going to show you how to make your own DIY fire starters […]

DIY Sofa C-Table w/ iPad Storage

Welcome to DIY for homeowners. We’re mother daughter projects. I’m Steph, I’m Vicki. Today, we’re going to make a simple C-table for my sofa. This is a brand new sofa for Steph and she wanted a small end table so she could put her tea her phone and her iPad which she uses as a […]

How to make a DIY metal detector / Easy Tutorial

https://www.instagram.com/romanursu/ https://www.instagram.com/romanursu/ https://www.instagram.com/romanursu/

How to make a mini Hydrogen Generator / TUTORIAL

您需要準備這些東西 2個同尺寸的冰棒棍 在棍面上畫上鑽孔點 再叧一根棍面上重做一次 再穩穩的將兩根冰棍壓緊 鑽孔 鑽孔後就像這樣 每相隔一個孔鎖上一個螺絲並穿過兩冰棍 再換面重做一次 再螺面上焊上錫點(可視螺絲材質選用合適的錫) 換面重做一次 然後 再螺面錫點上焊上電線 現在 可以將導電模組放入玻璃瓶中 瓶蓋上要鑽一個合適孔徑的洞 拿出西藥房買的滴管組 切掉上端 將電線穿過瓶蓋開孔 再將滴管組的觀察室塞進孔中,盡量塞緊 再用熱融膠封口,確保氣體不外洩 鎖緊瓶蓋 再依據實際需求剪截滴管 在集氣瓶鑽2個合適大小的孔 將滴管末端由孔1塞入瓶中 一定要將管子穿到瓶底 再將裁剩的那截滴管由孔2穿入瓶內.不必穿太深 再以熱融膠封口 這時 可以倒入清水了 蓋上瓶蓋 取一些鹽加水攪均 再打開瓶1 (導電模組) 倒入剛才自製的鹽水(導電液) 要淹滿整個導電模組 鎖緊瓶蓋 現在可以將電線接上電源供應器了 調整輸出電壓為 2.1 伏特 現在 您會看到瓶內開始有汽泡產生 (泡泡測試)

Battery Spot Welder (CD Welder) || DIY or Buy

In a previous project video I showed you how to create a battery pack out of 18650 lithium ion batteries. Back, then I utilized a rather riskier and not recommended methods of connecting the battery cells together. By soldering the nickel strips directly to them. This can be dangerous because you heat up the battery […]

Easy Copper Soldering

Today we are going to take the mystery out of soldering copper water lines. Give me a minute and I’ll show you how to do it too. Some of the supplies and tools you’ll need for this job is a self-cleaning plumbing flux a flux brush fitting cleaning brushes plumbing solder a tube cutter a […]