FUSE PEEKER Super Sensitive Probe

Fuse-Peeker and Signal Conditioner Probe… The Signal Conditioner Amplifier, is a protection and signal filtering oscilloscope add-on, meant to add redundancy to your electronic equipment. The Fuse-Peeker, is a Super-Sensitive Current Probe, that’s used as a fuse substitute. In other words, you remove the circuit fuse from the panel, and connect the Fuse-Peeker Probe. At […]

Connecting the Fuse Peeker

Automotive Fuse Peeker Unpacking… The Fuse Peeker is a dynamic current probe, for your car’s fuse panel diagnostic. Following, we will see the contents of the automotive fuse peeker set, as you’ll receive when you purchase it. The fuse peeker is composed of the following… The Fuse Peeker box, which has all the current sensing […]

FUSE Platform Sensor

The fuse sensor is a wearable device that monitors dynamic body movements and specific environmental factors It allows for real-time Accurate data insight into the safety risks of industrial workforces and workplaces The sensor is calibrated to monitor motion from the left ribcage where it clips into the fuse harness Wearing a sensor is engineered […]

Solar Lantern Torch Flame?(Hang, Stake or Tabletop) Ollivage Lights ?

welcome back to the channel today I have some new LED solar lanterns these are from Ollivage and I’m going to open the box and show you what’s inside so each box contains two solar lanterns and at the top you get the space right here it also does come with clips so you can […]

pH electrode handling 5/6 – storing

♪ [music] ♪ The Perfect InLab pH Electrode Handling, 5. Electrode Storage. For short-term storage, place the electrode in a beaker with pH 7 or pH 4 buffer or electrolyte solution. For long-term storage, close the refilling hole. Fill the wetting cap with appropriate electrolyte and put it on the membrane. Make sure that the […]

pH electrode handling 2/6 – preparation

METTLER TOLEDO ♪ [music] ♪ The Perfect InLab pH Electrode Handling 2. Electrode Preparation. ♪ [music] ♪ For SteadyForce electrodes carefully remove the silicone seal with the enclosed knife. Don’t scratch the membrane! For electrodes with sleeve junction check the sleeve and tighten with approximately 1/4 rotation. Don’t tighten too much! A jammed sleeve junction […]

pH electrode handling 1/6 – unpacking and quality check

Mettler Toledo The Perfect InLab pH Electrode Handling 1. Unpack The Electrode Electrodes must be investigated for damage and proper functionality immediately after receiving. ♪ [music] ♪ Most electrodes are made of glass careful handling is required. Archive the operating instructions and quality certificate for later use. Refillable electrodes come with a reference electrolyte bottle. […]

pH electrode cleaning – 4/6

METTLER TOLEDO The Perfect InLab® pH Electrode Handling 4. Clean The Electrode Rinse the electrode with deionized water for normal cleaning after each measurement and calibration. ♪ [music] ♪ If needed, gently tab dry the membrane. If cleaning with deionized water is not effective, rinse with Ethanol or Acetone. ♪ [music] ♪ Clean the electrode […]