G.G. Schmitt Completes Welds Faster With Dynasty Welders

When you start off with a new product it’s the learning curve. Miller came in and did training, and the interface became very, very user friendly. Once they’re hired, they get the job, everything, I put them in the Dynasty, and that, like, you can see the smile on their face how it makes their […]

Marine Manufacturer Cuts Hours of Rework on Aluminum Welds

G.G. Schmitt was established in 1951 out of Lancaster, Pennsylvania. We have this location that we’re at here today in Sarasota, and we also just started a new facility up in Summerville, South Carolina. Our primary market is the marine industry throughout the United States. We service all the OEM boat builders, the customers that […]

Miller Service Important to Marine Hardware Manufacturer

With all the challenges here today, equipment is certainly one of the concentrations. Equipment and support from that manufacturer. Support was probably one of the biggest things that drew us to the Dynasty 400. Customer service and our local rep, huge advantage over the competition. Whenever there’s an issue and we make a call, Miller’s […]

G.G. Schmitt Reduces Rework by 10% With Dynasty Welders

We reduced our scrap rework with the 400, in the 6 to 8% range and it keeps going up every month. And we’re starting to see, 10 to 11% less scrappage of the BDA from the arc out. And it’s helping on time, it’s increasing efficiencies. And it’s also increasing productivity at the same time. […]

Avoid Common TIG Welding Problems with a Dynasty TIG Welder

My biggest challenges with the welding of any material is sooting. I don’t like to see the fuzz around the weld and if there if there is going to be sooting around it I prefer to be white and sometimes I’ve get a little bit of a darker dingy colored sooting, especially on restart. To […]

Welding Aluminum With the Dynasty 280 DX Multiprocess Welder

To set up the Dynasty 280 DX Multiprocess to weld aluminum using an ArcReach 12 SuitCase feeder, there are a few considerations to get optimal performance with this solution. Use 3/64 inch Hobart MaxalMig 4943 or 5356 wire and a 300 amp Bernard gun. Install the appropriate U-groove drive rolls and contact tip. For better […]

Dynasty 280 DX Multiprocess Setup: Flux-Cored Arc Welding

This is how to set up the Dynasty 280 DX Multiprocess for welding steel using an ArcReach 12 SuitCase feeder, 1/16 inch Hobart XLR-8 wire, and a Bernard Dura-Flux gun. First, install the appropriate drive rolls and contact tip. With all connections complete, select the V-Sense mode on the front of the Dynasty. When using […]

Welding an Aluminum Surge Tank with Pratt & Miller