Remove Complexity With EZ-Set Technology

Setting parameters on welding equipment is a challenge today, because we have welders of different skill levels and a lot of advanced features that makes it a lot harder to set equipment up. EZ-Set on the new Deltweld helps with that, because if you don’t know where to set your wire feed speed or your […]

Review Of Electronic Welding Helmet From Harbor Freight ~ by Old Sneelock’s Workshop

Guts & Bourbon – music Hi I’m Old Sneelock Welcome to another episode of Old Sneelock’s Workshop I’m going to have to get one of those electronic helmets. Cause this one Though it works fine For Stick Welding Is not allowing me to hold my head in the proper position To do a good job […]

Welding Aluminum With the Dynasty 280 DX Multiprocess Welder

To set up the Dynasty 280 DX Multiprocess to weld aluminum using an ArcReach 12 SuitCase feeder, there are a few considerations to get optimal performance with this solution. Use 3/64 inch Hobart MaxalMig 4943 or 5356 wire and a 300 amp Bernard gun. Install the appropriate U-groove drive rolls and contact tip. For better […]

Dynasty 280 DX Multiprocess Setup: Flux-Cored Arc Welding

This is how to set up the Dynasty 280 DX Multiprocess for welding steel using an ArcReach 12 SuitCase feeder, 1/16 inch Hobart XLR-8 wire, and a Bernard Dura-Flux gun. First, install the appropriate drive rolls and contact tip. With all connections complete, select the V-Sense mode on the front of the Dynasty. When using […]