Metal Shaping with Lazze: Rolling a Bead with a Wire Edge

Hi I’m Lazze and I’m teaching people in metal shaping. And I’m here back again now on YouTube with tips and tricks. And on this little video I going to show you how to make this wire edge where we put the wire in and the bead. And this was a question that I had […]

Metal Fab Tech Tip: Pre-Stretch Metal Before Bead Rolling – Eastwood

and you guys that have done a lot of be growing i’m sure you’ve come across this problem like we’re showing right here have a nice flat paddle you lay all your beads out roll your beads perfectly straight you think everything is great you pull it out and well it’s just like this it’s […]

Making Motorcycle Gas Tanks – Part 2

These are selected scenes from the 166 minute long ‘Making Motorcycle Gas Tanks’ DVD. Check out all the Covell DVDs at covell.biz ! That’s kind of a rough sketch, but I think that’s more or less the shape I want to have for this tank. And we’ll put a soot coating on this piece of […]

Learn How to Use An English Wheel – Lots of Tech Tips From Eastwood

hi Mike Phillips hot rods and customs and Don Pennsylvania today we’re going to show you some tips and tricks on how to use the English wheel few ways you might not have thought of before right down to make it complicated shapes like this large reverse curve let’s get started there’s three different ways […]

Covell Workshops for 2019

Hello I’m Ron Covell. I’ve just completed my schedule of workshops for 2019. I’ve selected five very exciting locations this year – let’s look at the lineup. My first workshop will be at the Rydell GM Auto Center, in Grand Forks, North Dakota. This shop has the distinction of building many top-end cars, and they […]

Assembling and Welding an Aluminum Bicycle Frame

In the last video, I made the fixture that holds all the frame components in the proper location. This time, I’ll cut the monocoque elements and curved tubes to fit. The seat tube needs to be notched at a 12 degree angle where it meets the housing for the rear shock. I’m using a strip […]

How to Build a Custom Transmission & Driveshaft Tunnel – Ford Model A – Eastwood

the last step of this project we showed you how we made the floor pans for my model way back here the next step is going to be building the drive shaft and transmission tunnel for the car which a lot of people can find challenging to make now if we were back in the […]

Motorcycle Fender Fab! Building a Cafe Racer Fender from Scratch with Eastwood tools.

everybody it’s matt from eastwood we’re here in the eastwood garage doing another live-text session if you guys haven’t watched one of these before we want them to be as interactive as possible so what you guys to logon asked questions about the topic we have today share it with your friends and more people […]