Speedwire Dispense System Demo

Speedwire Dispense System Demo


The following video will provide step-by-step
instructions for loading the Speedwire dispenser. It is very important not to remove the loading
tool before instructions indicate to do so. Earlier removal will result in interior spring
and plunger loss. Before loading the dispenser for the first
time, remove parts from the body tube. Your speedwire dispenser is supplied with
the spring, plunger, and guide tube in position. Insert the white plastic axle into the left
side of the dispenser so it is secure but not protruding into the wheel cavity. Insert the straight end of your coiled laser
wire into the back of the dispenser until it emerges into the wheel cavity. Gently guide the wire into the guide to push
wire into the guide tube at least 10 millimeters. Place the clear body tube over the wire coil
and snap onto the back of the dispenser. With one hand, gently pull down on the loading
tool to release pressure on the guide tube. While pulling down on the loading tool, pull
the guide tube forward until it is no longer visible in the wheel cavity. Note the wire should follow the guide tube. Do not remove the loading tool yet. Use the hex wrench included in the package
to tighten the set screw. It is important to note to tighten only enough
to hold the guide tube in place. Examine the feed roller to locate the side
with the beveled hole. Place the beveled side so that it is aligned
with the plastic axle. Hold the roller in place with your thumb. While still holding the feed roller in place
pull on the loading tool until it detaches from the dispenser. Push the axle through the hole in the feed
roller. Use the hole in the tapered end of the loading
tool to push the axle into the feed roller. Using the flat surface of the tapered end
of the loading tool, push the axle completely into the hole on the opposite side of the
wheel cavity. Rotate the feed wheel toward the rear of the
dispenser until the wire emerges from the guide tube. Your speed wire dispenser is now ready for
use.

Leave a Reply

Your email address will not be published. Required fields are marked *