Lazze Metal Shaping: Tricks Using Magnets to Make Working Easier

Lazze Metal Shaping: Tricks Using Magnets to Make Working Easier


So when we building a car body we using something
that is very unique, actually and we using very strong magnets. And because when we make
the left side and then we make the right side of the cowl, and then we make the door but
then we going to put the pieces together; how do you hold that piece there the door
together with the cowl, it’s almost impossible. So I figured out and find out those magnets.
So if we put four of those magnets it’s going to hold the whole door, we can adjust the
bead up and down, and we can adjust the gap between the cowl and the door. When that is
right we can just tack weld it together with a MIG and it stays there. Then we can take
those magnets and we put them on the rear quarter panel and do the same there. Then
we can start to adjust the body so it has the right dimension inside and then cross
support it with some bars inside there or pipe. So this is really, really good. But
I also find out another thing that we can use it for. And I going to go over to the
table with those. We can also use the magnets to hold a trunk lid or a door or something
like that because we can use those and it actually give the panel legs. And it doesn’t
move as much as it sits on the convex shape and on the skin on the table. So those give
the piece legs that is really, really great and I find out that. And if I using a little
rubber on the table those stays even better so it doesn’t move around. And if this is
for the trunk lid you can bend the edge here with a bead roller, and shrink it and stretch
it, and then you can hammer and dolly it here and nobody else need to hold it for you. So
those magnets are really, really good. Another thing is that you can use it for is if this
is a roof skin you can hold the whole roof skin on the car like this. And you can look
at it and maybe push it up or push it down. And when you are done with that then the magnets
hold it where you want it to be. You go on the inside and you scribe it on the inside,
and then you trim it exactly on the line, put it together and keep the magnets over
again to hold it in place. And that will take hours and hours of rough work to, to hold
it in place. But the magnets it’s so simple and makes life so much easier and more fun
when you weld pieces together. The only thing you need to be concerned about is that you
don’t use or TIG weld it too close to the magnets because you think something is wrong
with the TIG welder. So you can’t weld too close to the magnets but that’s okay you can
move it around and you can TIG weld it together. They going to be available on the website
WWW.LazzeMetalShaping.com.

3 thoughts on “Lazze Metal Shaping: Tricks Using Magnets to Make Working Easier

  1. We were having challenges with the shopping cart. The new website and shopping cart will be up and operational in mid-March 2011, or you can call Monday – Wednesday! Thanks for looking!

Leave a Reply

Your email address will not be published. Required fields are marked *