How to Replace Your Rofin Laser Water Filter

How to Replace Your Rofin Laser Water Filter


Here are three maintenance parts on the Starweld
basic welder, four on the Starweld performance 7002. All the maintenance parts can be ordered from
Stuller. Once a year you should replace the water filter. You’re going to want to remove the back panel
to get to the tank. Unscrew the top hose and then unscrew the
water filter. Place the new filter in the tank and screw
on the hose making sure the plastic washer is in position. As a reminder the rope and welders require
you to fill it with either deionized or distilled water. The water filter for the performance is on
the left side. Open the side panel, unscrew the bottom screw,
and pull out the water tank. Unscrew the hose and then unscrew the water
filter. Place the new filter in the tank and screw
on the hose making sure the plastic washer is in position. Turn the machine on and allow the water to
run for 30 minutes before using the laser welder. The protection glass needs replacing about
once every one to three years. Wipe it down once a month to remove dust and
dirt from the lens. Once the lens becomes too dirty unscrew and
replace.

Leave a Reply

Your email address will not be published. Required fields are marked *